Home

The best way to Create a Box to get a Cathedral Ceiling Fan

Ceiling fan mechanisms all make use of a facility that is conventional mount which is anchored to the ceiling joist. A carton is positioned on the motor with just the fan driveshaft observable appearing in the carton subsequent to the fan motor assembly is installed to the ceiling. The blades are subsequently set up on the rotating shaft. Cathedral ceilings are usually vaulted between 25 and 15 levels. What this means is that any box connected to the ceiling to protect the enthusiast may also must carry the exact same angle on either side.

Hold the card-board centered in the top of the ceiling. Draw on the angles of the ceiling line on the composition board. Cut on the angles on the card-board by means of a pair of scissors. Hold the card-board to the ceiling. Recheck the angle. Make mandatory cuts to the card-board until it fits the pitch of the ceiling.

Follow the angles onto 2 of the sections of oak length-wise. Center the top of the angle towards the top border of the oak plank. Follow the angle to the conclusion of the planks to the left and right side of the middle. Tip a tablesaw blade. Miter the ends of all sections of oak. With a bandsaw, cut on the angles that you outlined on both pieces. The angle should be match by the angle on the planks on the ceiling if you are finished.

Stand all bits up on their borders. Bring together all of the corners to to make a carton. Both of the other bits will not be matched by both boards with angles. Indicate the level where the angle is lower compared to present boards. Make use of a table saw to rip the two planks to satisfy with the the lower level of the angle.

Spread paste on all the corners. Bring the miters all . Roll the carton is clamped across by a nylon strap and tighten until adhesive oozes out from every corner. Wait one hour for the adhesive to dry. Turn the box upside-down. The angles therefore brace with scrap wood and then under it is likely to allow it to be unstable and clamp it to the very top of the work-table.

Install a 1/4-by-1/2-inch dado bit with bearing in to a layer 3 switch. Turn on the router and operate it around the within margin of the carton to produce a 1/4-by-1/2-inch dado. This can be for when ended, the plywood protect to be installed.

Set the framework, 1 side at a time, in a pocket-hole jig. Tighten the clamp on the jig and use a 3/16-inch drill-bit and a cordless drill to drill pocket holes six inches aside around the border of the framework. These are for pocket screws employed to fasten the box

Gauge the recess on the carton and cut on a part of 1/4-inch plywood to to suit it utilizing the dining table noticed. Centre and minimize a-6-inch hole in the plywood using a jigsaw. This can be for the fan rotating shaft assemble to to feed.

Sand the box -grit sand-paper attached to some hand block. Stain and lacquer the carton as before installing required.

Centre the carton within the enthusiast shaft. Add 3-inch screws in to every one of the pocket holes. Work with a cordless drill to twist the box. Put the 1/4-inch plywood protect on the carton. Twist it to the box utilizing 1/2-inch brass screws. Set the fan blades on the lover.

See related

Tags :